OGSI OG-75, Инструкция по установке, эксплуатации и обслуживанию

Страница: 14 / 52

Effective April 2006
11
Pre-Installation Check Instructions
Although every Oxygen Generator is thoroughly tested and checked before it is
shipped from our factory, the following checks are necessary to insure that none of
the internal components have been damaged in shipment. This check should take
less than five minutes to perform.
1.) Make a visual inspection of the machine and make sure all parts are properly
attached.
2.) Sieve settles during shipment, therefore it is important to re-pack the supplied
sieve to the top of the sieve beds making sure no empty voids are left in the beds.
The sieve can be harmed by exposure to air and caution must be taken to keep the
sieve in the oxygen generator & the container sealed as much as possible. (See
page 12 for diagram.)
3.) The ON/CONTINUOUS/AUTO switch will need to be attached to the enclosure
door. (See page 13 or 14 for a diagram depending on the type of switch you have.)
4.) These checks are for machines with the touchscreen option:
a. Ensure the touch screen is powered, and a display is visible. Consult the
troubleshooting guide in this manual (see page 14) for any problems
encountered.
b. After selecting a language and entering a password, start the machine by
pressing both the OPERATING MODE (Automatic), and then the ON/OFF
pushbuttons.