Ogden Metalworks, Inc. — 217-582-2552
18
Hay Runner™ Hay Rake
4.10 Optional Center Wheel Kit
The Center Wheel Kit mounts on the front of the
wheel rake and is designed to move the hay that
lays in the center of the row that would not be
moved by the main rake assemblies.
Use the hydraulic valve on the cylinder to raise and
lower with the center wheel rakes.
When transporting, raise the center wheel rakes
then close the hydraulic valve.
Use the following instructions and the parts book
page as item number reference to install the center
wheel kit on the tongue extension.
1. Start by attaching the rake to a tractor. Unfold the
rake arms with the rake wheels flat on the ground.
CAUTION
Release all hydraulic
pressure.
2. Loosely attach mount plate (1) to the tongue
extension using two 5/8” U-bolts (5), four lock
washers (6), and four hex nuts (7).
Note:
When mounting the plate, the end with the
largest gap between the ear and the U-bolt
faces the front.
3. Slide the mount plate forward until the U-bolt
hits the weld on the tongue extension but stays
straight perpendicular to the plate. Tighten the
four nuts.
4. Install left-hand rake arm (8) in the front ears of
the mount plate and right-hand rake arm (10) in
the back ears using pivot pin (2), flat washer (3),
and a cotter pin (4).
Note:
Insert pivots pins (2) from the rake wheel side
with the two bent ears facing up and sliding
around the ear of the mount plate.
5. Loosely install cylinder mount plate (37) with
the welded lug angling backward with two 5/8”
U-bolts (5), four lock washers (6), and four hex
nuts (7).
6. Position the back of the cylinder mount plate
42-1/4” from the front of the pivot mount plate.
7. Install cylinder (27) with the fittings facing the left
side of the rake to the cylinder mount plate. Install
cylinder pin (28) with cotter pin (4).
8. Extend the cylinder rod and connect it to the
linkage arm (9) using cylinder pin (28) and cotter
pin (4).
Note:
The slots in the linkage arm are convex
shaped, and the ends must be installed
facing upward like a smile (not a frown).
9. Attach each rake arm to linkage (9) using pins
(41), washers (3), and clips (29).
10. Use one hose (33) and connect it to the
cylinder’s rod end port and then into the t-fitting
in the system’s supply hose.
Содержание RCR812
