Hay Runner™ Hay Rake
17
Ogden Metalworks, Inc. — 217-582-2552
4.7 Hay Rake Wheels
1. The hay rake has right and left-hand rake wheels,
and it is important they are installed correctly.
2. The rake tines at the bottom of the wheel where
the tine touches the ground should point forward
(toward the tractor).
3. The carriage bolt heads in the center of the wheel
that bolt down the rake tines should be on the
side of the wheel that touches the hay.
4.8 Adjust Height of Hitch
NOTICE
The tongue clevis is adjust‑
able and should be adjusted,
so the rake is as level as possible when raking.
1. Remove the two retaining bolts and adjust the
hitch to the desired height.
2. Reinstall both mounting bolts and tighten the
hardware.
CAUTION
Use only OEM‑supplied
hardware to mount the
hitch to the hay rake frame. Use of a lesser grade
bolt could result in failure of the hitch causing
property damage or personal injury.
4.9 Grease the Pivot Pins
Once the unit is assembled, grease the following
three pivot point locations. If the rake has been sitting
for an extended period of time, refer to the Lubrication
section and grease the remaining grease points.
1. Grease the two mainframe hinge pins; one on
each side.
2. Grease the two rake arm hinge pins; one on each
side.
3. Grease the rake arms. Move the arms up
and down several times to ensure complete
lubrication.
The zerks for the rake arms are on the bottom side of the tube.
Содержание RCR812
