Ogden RCR812, Руководство пользователя

Страница: 24 / 52

Ogden Metalworks, Inc. — 217-582-2552 22 Hay Runner™ Hay Rake
CAUTION
The wing extension
weighs approximately
42 pounds and may cause crushing injuries if
not handled properly. Do not place any part of
your body in a pinch point location while making
these adjustments.
5. Retighten the U-bolt nuts to 315 ft. lbs. of torque.
5.6 Rake Angle Adjustment (rear center
rake wheels)
The angle of the rear four center rake wheels can
be adjusted to operate at a steeper angle in heavy
crops or at a flatter angle in light crops and still
maintain the desired windrow width.
1. Using the tractor hydraulics, slightly raise the
wings off the ground and shut the tractor off.
CAUTION
Shut the tractor off and
apply the parking brake
before making this adjustment. DO not place any
part of your body under the wing of the rake.
SAFETY
INSTRUCTIONS
As an added precaution,
support the wing in the
raised position to prevent it from lowering to the
ground while the adjustments are made.
2. Loosen the threaded tear-shaped lock tab.
3. Pivot the rake arm to the desired angle using the
turnbuckle.
4. Retighten the threaded lock tab.
5. Repeat the process for the other wing.
5.7 Rake Angle Adjustment (front center
rake wheels)
The angle of the front four rake wheels (including
the additional rake wheels on the 10 and 12 rake
wheel models) can also be adjusted to six different
settings to adjust the overall width.
1. Remove the nut and washer from the lock pin.
Remove the pin and slide the rake wheels into
the desired angle.
2. Reinsert the lock pin. Install the flat washer and
nut and securely tighten the nut.