OFITE, 11302 Steeplecrest Dr., Houston, TX 77065 USA / Tel: 832-320-7300 / Fax: 713-880-9886 / www.ofite.com
15
“Cool”
- Place a check in this box to activate the cooling solenoid and
begin cooling the sample. The value in the “Temp” field must be lower
than the sample for the software to initiate cooling.
“Clear”
- This button removes all data from the graph.
“Analysis Model”
- This field, below the graph, displays the current Analysis
Model being used in the test. This variable is set in the Test Builder (refer to
page 25 for more information).
“Analysis Data”
- This chart shows the calculated values based on the
Analysis Model being used for the test. This data will not display until after the
analysis sweep is completed.
“Temperature”, “Shear Stress”, “Viscosity”, “Shear Rate”, “RPM” -
These fields display the current value for these variables. They are display
only. The drop-down box next to the “Shear Stress” field changes the units of
the Shear Stress variable. The units can be set to: Dyne/cm
2
, lb/100ft
2
, Pa.,
Dial Reading, lb/ft
2