Officine Gullo CVCS4G, Инструкция по установке и эксплуатации

Страница: 11 / 24

11
Officine Gullo
CHECKING FOR ADEQUATE VENTILATION
Make sure that the air intake into the room where the appliance is installed is sufficient for an
adequate change of air, as specified by regulations in effect.
The appliances installed in buildings open to the public must satisfy the following requirements.
Installation rules
The installation and maintenance of the appliance must be done according to the correct
procedures and regulation
texts in use, particularly:
• safety standards for the prevention of fire and panic.
Connection and installation of appliance, ventilation and exhaust removal systems, shall be done
according to the Manufacturer’s instructions and by qualified technicians and according to the
regulations in effect. The electric wiring shall conform to the regulations in effect.
All fire prevention codes shall be observed.
a) General indications (Rules valid for GB only)
- For all appliances:
Gas safety Regulations, 1984; Health and safety at Work Act, 1974 Codes of Practice, BS 8173,
1982, The Building
Regulations 1985; The Building Standards Regulations, 1981, the IEE Regulations and the by-
laws of the local Water Undertaking.
The local gas Region or LPG supplier and the local authority and the relevant recommendation
of the British Standards (latest editions) concerned.
The installation, transformation and repair of appliances for professional kitchens as well as
removal due to malfunction, and the supply of gas, may be made only by means of a maintenance
contract stipulated with an authorized sales office and in observance of technical regulations.
The appliance can be installed by itself or in a series side by side with appliances produced by us.
There must be a minimum distance of at least 10 cm between the appliance and the sides of the
nearby cabinets made of inflammable material.
Take suitable measures to guarantee thermal insulation of the inflammable sides, such as, for
example, the installation of protection against radiation. The appliances must be installed in
a suitable manner, observing the safety standards. The small feet are adjustable to level the
appliance.
PIPE FOR GAS CONNECTION
The gas connection must be done with steel or copper pipes, or otherwise with flexible steel
pipes in compliance with the national norms, if such exist. Each appliance must be provided
with a cutoff cock for rapid interruption of the gas supply.
Once the appliance has been installed, it is necessary to check for gas leaks from the pipe
fittings; do not use a flame for this purpose but a non-corrosive substance such as soapy
water or the specific leak-finder sprays. All our appliances undergo careful testing: the type
of gas, the operating pressure and the category are indicated on the data plate.