Officine Gullo CVCS4G, Инструкция по установке и эксплуатации

Страница: 16 / 24

16
Officine Gullo
STARTING UP
Before using the appliance, it is necessary to clean it carefully, especially the water tub
(see paragraph “cleaning and care”).
Check the connection of the appliance and start it up following the instructions,
“Instructions for use”.
Attention! - Use the appliance only under surveillance.
WATER FILLING
Check that the drainage tap is in the “off” position.
Fill the tub with water up to the level indicated by the mark.
LIGHTING AND ADJUSTING THE MAIN BURNER - MOD. CV...
On the front panel, above each knob, the burner it corresponds to
is indicated by the index
To light, turn the knob to the left from position “0” to the
symbol (see figure);
keep it pushed down and press the button with the symbol until
the gas lights
Keep the knob pressed a few second and then let it go, this lights
the pilot.
If the flame goes out you have to repeat the procedure.
By turning the knob round to the position the burner is at maximum.
By turning the knob round to the position the burner is at minimum.
To switch off, move the knob back into position " 0".
OPERATION MOD. CVC…
1) When powering the green on-off device, the red light flashes briefly for about ½
second.
2) In the absence of water in the tank the red light keeps flashing.
3) Turn on the tap to load the tank to the desired level, which must be higher than the
minimum level probe and do not exceed the maximum level, which is marked on the tank
by the symbol (―)
4) Turn the gas knob to the position and hold it down.
At the same time, press the button to turn on the gas to light the
pilot.
5) Turn the gas knob to the
position: The burner will remain off
until the water reaches the minimum level probe.
6) To set the burner to the minimum, turn the gas knob to the
position