6.2.2 Switching
Off
•
Switch the mains switch off.
CAUTION: Waiting Time
Wait for at least 5 seconds before switching on the device again.
6.3 Operation
Modes
The DISPLAY ONE may be operated in the following modes:
•
Measurement Mode
The measuring mode is the standard operating mode. Here the measured values of the
sensors are displayed.
)
Chapter 6.4 Measurement Mode, page 15
•
Parameter Mode
In the parameter mode you have the possibility of changing over the
configuration
switch at the rear of instrument different parameters of the
DISPLAY ONE.
)
Chapter 6.5 Parameter Mode, page 16
6.4 Measurement
Mode
6.4.1 Selection
After switching on the DISPLAY ONE it will automatically run the measuring mode.
6.4.2 Description
The measuring mode is the standard mode of operation. Here the measured values of the
transmitters are indicated. If no measured values can be indicated, a status message is
spent (
)
If no transmitter is attached at the measuring channel, noSEn indicated. This status
message expires after 30 seconds.
Display
Pressure
8.888
-8
Within the permissible range.
c8.88
-8
Below the measurement range (underrange).
Table 5
–
Display of the Measuring Mode
GA 09.034/2.02 – 07/10
15
