JBL Enhancement
TOYOTA Tundra
Procedure
Issue B 02/16/18
Page | 9
k. Disconnect the Factory sub connector and remove
sub assembly from vehicle.
(Fig. 8-9)
Using Needle Nose Plyers remover the factory
male sub connector by compressing the white
locking release found in the cavity of the factory sub
enclosure.
(Fig. 8-10)
With the factory connector loose from the enclosure,
take note of the wire orientation. The green wire
is positive and the black wires are negative. Use a
marker to note the placement, if helpful. The empty
slots of this connector will remian empty.
(Fig. 8-11)
With a precision screwdriver or pick tool, lift the
locking tab of the factory connector
(Fig. 8-12)
.
This
tab only needs to be lifted slightly to release the pins
in the connector. You will see the tab lifted, yet level,
when properly disengaged.
Fig. 8-9
Fig. 8-10
Fig. 8-11
Fig. 8-12
Black
Green
