JBL Enhancement
TOYOTA Tundra
Procedure
Issue B 02/16/18
Page | 12
9. Power Wire Installation
c. Route power wire to the driver side kick panel.
Run neatly and out of the way. Use cable ties as
necessary.
(Fig. 9-3)
d. Under the hood locate the grommet for the main
factory wiring harness on the driver side of the
fi
rewall directly under the two (2) heater hoses.
(Fig. 9-4)
e. Identify unused nipple and slice the tip off to
create an opening for the power wire.
(Fig. 9-5)
f. Lubricate power wire with silicone spray or
comparable substitute.
g. Once enough slack is visible, pull the full length of
the power wire through under the hood
(Fig. 9-6)
.
You want just enough length to reach your battery.
Cut any additional slack.
Note
: Avoid interference
with accelerator and brake pedals.
Fig. 9-3
Fig. 9-4
Fig. 9-5
Power wire
opening
Fig. 9-6
