X-SERIES
X4 / X8 / X16
.
INSTALL & OPERATION MANUAL
9
Installation (Once hull preparation is complete)
1. Test light(s) before fitting.
2. Fit the bezel over the light unit.
3. Apply generous amounts of the sealant to the back perimeter of the light body
①
and around cable where it meets
the back of the light
②
. There should be an unbroken bead of sealant around the perimeter of the light unit
①
.
It is critical to cover the entire body and circle the mounting screw holes so that there is a continuous
and unbroken bead of sealant.
4. To guarantee correct light orientation ensure the OceanLED logo
③
on the front is facing upwards. Insert the
light on to the hull, feeding the cable through first and seat into place. Press the light hard into the hull and twist
slightly to spread the sealant around behind the light to ensure good adhesion.
5. Cover the screws
④
threads with the sealant and screw into the pre-drilled pilot holes.
6. Tighten the screws with a hand tool ONLY! DO NOT over-tighten the screws, as you could damage the light
enclosure, and will void your warranty.
7. Once you are satisfied that the unit is fully tightened, you will notice that sealant has squeezed out from
around the perimeter of the light. Using a thinner or cleaner, apply to cloth and wipe off excess sealant to
leave a clean seal.
AVOID CONTACT WITH LENS
. If you do not see sealant squeeze out from the body,
you have not used enough sealant or tightened the unit enough to the hull. Carefully examine the
installation to make sure the sealant you have installed on the unit is fully watertight. If in doubt, remove
light, re-apply sealant and re-install.
①
②
③
④
