12
12
4
CHAPTER
FOUR
Chapter 4: Finalising your OceanLED installation
4.1 - Finalise your OceanLED Installation
WARNING
:
Always test the lights BEFORE the boat goes back into the water. Typical OceanLED light
installs
require the boat to be hauled out of the water to replace light units.
1.
For the wifi compatible
controller, if wifi is required
connect Ethernet cable from
back of controller panel
into a suitable wifi router or
wifi enabled network. (The
controller is DHCP enabled
as standard so should be
detected by the network
once powered).
2.
Connect the DMX controller
DMX output cable to the
DMX input of the first driver
box. The DMX output of this
box should be connected to
the input of the next, and so
on up to the last driver in the
chain.
3.
Fit the supplied terminator
to the output of the last
driver box. See the following
example of the DMX
connections:
OceanLED INSTALL / DMX Controller / 073114 / v4.2
DMX
Controller
DMX Out
DMX Out
DMX Out
DMX Out
DMX Out
DMX In
DMX In
DMX In
DMX In
Power In
Power In
Power In
Light Out
Power In
Terminator
Kit
Light Out
Light Out
Light Out
Light
Light
Light
Light
110/220V AC
Power
Driver
Driver
Driver
Driver
Ethernet
Router
(for Wifi DMX)
Power In
Power Supply
Example Installation
