Sauna & Steam
Oceanic Saunas 01902 450 550 [email protected]
7
Infrared Sauna Assembly
7. Add Roof
i. If you are installing the cabin with a restricted height (less than 2200mm) and have purchased
the “Low Height Kit” you will be supplied with an additional guide for fixing the roof.
ii. If you have a height of 2200mm or above please use the following steps.
iii. Start with the back roof panel, start from the corners to square up the wall panels, pilot and
counter sink holes and use 60mm screws, don’t screw near the cable holes.
iv. Fix the roof panels to each other in the centres check they are flush on the inside face.
v. When you fix above the door use 50mm screws so they don’t stick through top of the frame or
countersink and screw from underneath.
vi. If you levelled and squared the base properly
the door should open perfectly at this stage. If it
doesn’t you may need to pack the base up, use
a spirit level to make things easier.
vii. Fix the other side of the door if you haven’t
already done this at the previous stage.
