Oce TDS400-CS, Руководство пользователя

Страница: 268 / 326

268 User manual
'Printer asleep' The printer is in low power mode to save energy.
'Please wait' The printer downloads the language.
'Printer ready' The printer is ready to print.
'Preparing job' The printer prepares a copy or print job.
'Load roll 1'
'A2'
'Paper' The required media is not loaded on roll 1. Load the required media.
(see ‘Load the media’ on page 252)
'Load roll 2'
'A2'
'Paper' The required media is not loaded on roll 2. Load the required media.
(see ‘Load the media’ on page 252)
'Manual feed' The required media is not found. Feed the required media at the
manual feed table.
(see ‘Make a copy on a cut sheet’ on page 199)
'Conditioning' The printer optimizes the toner concentration. Please wait.
'Printer ready'
'Roll 1 empty' Media roll 1 is empty. Reload roll 1.
(see ‘Load the media’ on page 252)
'Printer ready'
'Roll 2 empty' Media roll 1 is empty. Reload roll 1.
(see ‘Load the media’ on page 252)
'Printer running'
'Roll 1 empty' Media roll 1 is empty. Reload roll 1 when the printer is ready.
(see ‘Load the media’ on page 252)
'Printer running'
'Roll 2 empty' Media roll 2 is empty. Reload roll 1 when the printer is ready.
(see ‘Load the media’ on page 252)
'Job cancelled' The active print or copy job is cancelled.
'Close roll unit' The roll unit is open. Close the roll unit.
'Sensor not free'
'Remove paper'
'Press <on-line>' The media of a roll was not in the start position while the printer was
turned on. Turn the media back into the start position and press on
line.
'Paper retracted'
'Press <on-line>' The cut sheet was retracted. Feed the cut sheet at the manual feed
table.
'Copy too short'
'Remove paper'
'Press <on-line>' Use an original longer than 420 mm.
System message Description / solution