OBI 210563, Оригинальное руководство по эксплуатации

Страница: 45 / 140

GB
45
• Make sure that the selected gap is the same for
all three wall brackets (8).
Figure 8 – Page 4
– Draw the 12 drill holes on your mounting surface
as shown.
• Pay attention to the different dimensions for cei-
ling and wall mounting (values in brackets refer
to ceiling mounting).
– Drill the 12 holes with a 12 mm drill bit suitable
for your surface.
Figure 9 – Page 5
– Screw the wall brackets (8) as shown using the
bolt anchors.
Installation sequence:
• Wall bracket, washer, bolt anchor
Figure 10 – Page 5
– With three people, place the awning into the wall
brackets (8).
• Pay attention to ensure that the rear fixture
rail (25) is hooked into the wall brackets (8).
– Align the awning by careful sliding laterally.
Figure 11 – Page 5
– Secure the holding plates (23) with the fixing
screws (22) to the wall brackets (8).
• Pay attention to ensure that the holding
plates (23) are hooked into the front fixture
rail (26).
Mounting the wind sensor
The semi-automatic wind sensor enables the auto-
matic retraction of the awning in unfavourable wind
conditions. After the wind has died down, the awning
will not be automatically extended again.
The wind sensor must be mounted outside the func-
tional range of the awning and may not be in a loca-
tion that is sheltered from the wind.
Figure 12 – Page 5
• The wind sensor can be mounted in three varia-
tions, as shown.
Figure 13 – Page 6
• Do not mount the wind sensor more than 20 m
away from the awning.
• When selecting the mounting surface, pay atten-
tion to ensure sufficient weather influence.
Figure 14 – Page 6
– Make the holes for mounting the wind sensor as
shown in your mounting surface.
– Drill two 40 mm deep holes with a masonry bit
8 mm with a gap of 85 mm between them
Setting the wind sensor
Figure 15 – Page 6
– Remove the cover (27) by sliding it out.
– Undo the fixing screw (28).
– Align the wind sensor and tighten the fixing
screw (28).
– Slide the cover (27) back into place.
Electrical connection
Laying cables
Connecting the wind sensor
Figure 16 – Page 6
– Connect the wind sensor as shown.
The wind sensor is set at the factory and does not
need to be programmed.
Connecting the motor
Figure 17 – Page 7
– Connect the awning motor (3) as shown.
Mounting the wall bracket for the radio remote
control
The mounting material for the wall bracket of the
radio remote control is not a component of this
scope of delivery.
Select suitable dowels and screws for the mounting
location you want.
Prior to mounting, select an appropriate location
indoors. Pay attention to ensure that the intended
mounting location has no electrical cables or similar
beneath the plaster.
– Drill tow holes.
– Insert two dowels.
– Screw two screws into place.
• Make sure that the screws are not screwed fully
into place.
– Hang the wall bracket for the radio remote con-
trol on the two screws.
DANGER! Risk of electric shock! The
electrical installation may only be carried
out by a professional electrician taking
account of the current legal requirements
(VDE 100) as well as national and regional
requirements. The enclosed installation
instructions for the supplied electrical
units must be observed.
210563_LED_Markise_elektr.book Seite 45 Freitag, 2. Oktober 2015 5:35 17