8.
CANCEL
- stops an on-going process.
9.
Air extraction
- Do not cover the intake with the vacuum bag when
vacuum packing/sealing.
10.
Vacuum channel
- place the open end of the bag in the vacuum channel.
The air is sucked out of the bag and the vacuum channel captures any
fluid from the bag.
11.
Seal strip
- seals the bag (removable).
12.
Lower gasket
- removable.
13.
Upper gasket
- removable.
14.
Sealing unit + Teflon tape
- seals the vacuum bag.
15.
Bag knife
- remove the knife from the console and pull the knife along
the plastic roll at the desired length.
16.
Release buttons
for opening and closing of cover.
Use
Produce a vacuum bag from a plastic roll
Place the appliance on a flat surface and connect the plug to a wall socket
(the signal lights Normal and Dry are illuminated).
1.
Open the appliance and take out the bag knife. Pull out
a suitable length of the plastic and run the knife along
the bag as shown. Adjust the length so that there is at
least 7 cm between the bag’s contents and the opening
of the vacuum bag. Only use plastic rolls from OBH
Nordica.
2.
Then place the short end of the plastic over the sealing
unit and down into the vacuum channel, make sure the
entire short end reaches down into the vacuum channel.
3.
Close the cover and push firmly until you hear a click
from both sides of the appliance.
4.
Push on the Manual Seal button to begin sealing; the signal light turns on.
Once the signal light turns off, the sealing is done.
88
7945_KK_UVN_0415.indd 88
2016-06-23 09:15:34
Содержание 7945
