OBELUX L864-MX-GA, Руководство пользователя

Страница: 12 / 28

MI SERIES
– Manual (v1.7)
Obelux Oy, Kutomotie 6 B, 00380 Helsinki FINLAND
© Obelux Oy 2017 Technical information in this document is subject to change without notice.
Page: 12(28)
5.2.3 DC input (DC versions)
Mark Description Information
+ Positive Power supply input positive
- Negative Power supply input negative
GND Ground Protective earth
Tighten the connector screws using flat-head (straight) screwdriver.
Conductor cross-section 0.2mm² - 2.5mm²
5.2.4 DC output (DC versions)
Mark Description Information
+ Positive Power supply output positive
- Negative Power supply output negative
GND Ground Protective earth
This terminal is used to distribute power from the light head to the next. Tighten the connector screws using
flat-head (straight) screwdriver.
Conductor cross-section 0.2mm² - 2.5mm²
5.2.5 Alarm Relay Output
Mark Description Information
NO Normally Open In alarm, connected with COM
COM Common Common relay contact
NC Normally Connected During normal operations, connected with COM
Unused alarm relay connectors can be left floating i.e. no wiring there is required. Push-in spring connection .
Conductor cross-section 0.2mm² - 2.5mm²
5.2.6 RS485 input (not available with L864-MX-GA)
Mark Description Information
D+ Data + RS485 non-inverting pin
D- Data - RS485 inverting pin
SH Shield Shield
The RS-485 network (bus) input. Push-in spring connection .
Conductor cross-section 0.2mm² - 2.5mm²