Oasis Aquatics SmartChem, Инструкция по установке и эксплуатации

Страница: 5 / 25

Oasis SmartChem - INSTALLATION AND OPERATION MANUAL Page 4 of 22
3. INSTALLATION
Mounting
IDEALLY, AS WITH ALL POOL EQUIPMENT, THE CONTROLLER SHOULD BE
INSTALLED OUT OF DIRECT WEATHER.
•
Find a suitable location to mount the control box.
• The controller should be mounted no closer than 3 metres from the water’s edge, at a minimum
of 600mm above the ground.
•
Fix the mounting bracket to a solid structure with the screw and wall plug kit provided. Slide the
controller on, locking it into place. Adjust the screws on the back of unit to ensure a snug fit.
•
To remove unit, lift and gently pull away from structure.
PACKAGE CONTENTS:
•
Oasis SmartChem controller (with a peristaltic pump attached).
•
pH sensor (or pH + ORP depending on which kit is being fitted).
•
Sensor Manifold (suits 50mm pipe, 2 reducing bushes required if installing into 40mm pipe) for
the sensors to mount into (the centre of the inputs will be drilled out to accommodate the sensor
probes).
•
A power cable providing power to the Oasis SmartChem from a valve actuator port
•
A communication cable to connect the Oasis SmartChem to either the Maser controller (if no
Expansion Units are connected) or an Expansion Unit (if fitted).
•
A check valve.
•
An Injection Manifold (suits 50mm pipe, 2 reducing bushes required if installing into 40mm pipe)
for the injection hose to be connected to.
•
A bottle/tub connection kit (including lids, breather connection and bottle/tub tube).
•
A 5M length of tubing.
•
Blanking caps.
Installation Diagram
WARNING: DO NOT plug in if carton has been wet
Filter
Filter Pump
Pool Suction
Solar Suction
Solar Return
Heater
ORP & pH Probes in
Sensor Manifold
Chlorinator Cell/
Ioniser Housing,
Ozone Venturi, etc
Injection Manifold
Pool Return
AQUACHEM AQUATEK/EXP
Through Shed
Connection
Check Valve
Acid Tub
Oasis Smart / EXP
Oasis SmartChem