Oase ProfiClear Premium, Руководство по эксплуатации

Страница: 24 / 132

24
- GB -
5.4 Pump fed system without ProfiClear Premium Individual Module: Fitting the discharge set
If no further ProfiClear Premium filter module is connected to the filter module outlets, the height of the
latter needs to be increased. This ensures the required water level in the filter container. The height of
the pipe bend outlet determines the rise level of the water in the filter container. Based on the physical
principle of communicating pipes, the water balances out to the same level in all containers.
OASE provides a suitable discharge set (Order No. 50949). It consists of two pipe bends/DN 110
adapters with holding plate.
4.
How to proceed:
H
1. If not already done: Fit the sealing ring into the wall of the container from the outside.
−
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
2. Fit the outlet adapter to the sealing ring.
−
Ensure that the raised marking is at the top and aligned in relation to the hole pattern.
3. Fasten the sealing ring and outlet adapter from the inside with oval head screws.
−
Tighten all screws diagonally using the cordless screwdriver to ensure that the sealing ring is
uniformly applied. Further tighten the screws using a Phillips screwdriver.
4. Fit the pipe bend set together in the specified order and fasten to the outlet adapter.
5. Guide the holding plate over the pipe bend and align the pipe elements if necessary.
6. Insert the screws with expansion seals through the holes from the inside. Screw the holding plate
from the outside to the container wall with cap nuts.
5.5 Returning the water to the pond
Once it has passed through all the cleaning stages, the clean water has to be returned to the pond.
There are various possibilities for this depending on the system used (please refer to the operating
manual for the Individual Module).
18172-07-13_GA_ProfiClear Premiu24 24 25.07.2013 12:58:55