Oase Jumping Jet Rainbow Flash II DMX/02, Руководство по эксплуатации

Страница: 26 / 36

26
- EN -
7 Start-up
Attention! Dangerous electrical voltage.
Possible consequences: Death or severe injury.
Protective measures:
►
Prior to reaching into the water, switch off the mains voltage to all units used in the water.
►
Switch off the mains voltage prior to carrying out work on the unit.
The unit should be only switched on when it is filled with water and the positioning of the unit is in
accordance with this guide – see chapter 5.3.
Is the length of the water beam adjusted, the beam cover plate has to be fixed so that the beam exits the
cover. For this, the cover plate has to be adjusted by hand.
7.1 Setting the water jet
The water jet of the Jumping Jet Rainbow Flash II has a parabolic shape. The jet height and range are
determined by the pump rating (flow rate) and the inclination angle of the Jumping Jet Rainbow Flash II.
Jet height, jet range and water quality notably influence the quality of the water jet and the light emittance.
The diagram shows parabolas of the water jet with different beam angles of the Jumping Jet Rainbow
Flash II by optimal environmental conditions (without wind) and a maximum flow rate of 72 l/min with a
pressure of 0.35 bar.
45° Parabola Jumping Jet Rainbow Flash II/DMX/02
Fountain width DWB l/min DDB bar
1,25 mm 30 0,10
2,00 m 36 0,15
3,00 m 46 0,20
4,00 m 54 0,25
5,00 m 63 0,30
6,00 m 72 0,35
►
Please note the specified maximum water level height.
►
Place the unit at a wind protected location. Risk of the water jet being broken apart by wind.
►
Never guide the water jet beyond the basin rim, as in this case splash water cannot be avoided.
►
Do not locate the water jet point of contact too close to the pump (> 1 m).