O-Mac MS 2700, Руководство оператора

Страница: 47 / 88

47
the cutting means.
4.4.2 Mounting the cutting means guard
(saw blade, if allowed)
This protective guard should not be used
for other cutting means.
1. Remove any protective guards used for
other cutting means.
2. Position the guard (Fig. 7.B) in line with the
holes on the transmission (Fig. 7.A).
3. Secure the guard (Fig. 7.A) by fully
tightening the screws (Fig. 7.C).
4.5 Fitting and removing the cutting means
Wear protective gloves.
4.5.1 Fitting the cutting line head
1. Fit the inner lock ring (Fig.8.A) on the shaft
in the indicated direction, making sure that
the grooves are perfectly coupled with those
on the angle transmission (Fig. 8.B).
2. Insert the wrench supplied (Fig. 8.C) into the
appropriate hole on the angle transmission
(Fig. 8.D) and rotate the lock ring by hand by
pushing the wrench (Fig. 8.C) until it engages
and blocks rotation.
3. Fit the cutting wire head (Fig. 8.F) by
screwing it anticlockwise.
4. Remove the wrench (Fig. 8.C) to reset
rotation.
IMPORTANT When using the wire head, the
guard (Fig. 8.E) must always be fitted with a
wire cutter blade (Fig. 24.A).
4.5.2 Removing cutting wire head
1. Insert the wrench supplied (Fig. 8.C) into the
appropriate hole on the angle transmission
(Fig. 8.D) and rotate the lock ring by hand by
pushing the wrench (Fig. 8.C) until it engages
and blocks rotation.
2. Remove the wire holder head (Fig. 8.F) by
unscrewing clockwise.
4.5.3 Fitting the 3-point, 4-point and 8-
point blade and saw blade (if allowed)
Apply the guard to the blade.
1. Mount the inner locking ring (Fig. 9.A, Fig.
10.A) on the shaft in the indicated direction,
making sure that the grooves are perfectly
coupled with those on the angle transmission
(Fig. 9.B, Fig. 10.B) .
2. Fit the blade (Fig. 9.C, Fig. 10.C) and the
outer locking ring (Fig. 9.D, Fig. 10.D) with the
flat part facing the blade.
3. Insert the wrench supplied (Fig. 9.E, Fig.
10.E) into the special hole on the transmission,
rotate the blade by hand (Fig. 9.C, Fig. 10.C)
and push the wrench (Fig. 9.E, Fig. 10.E) until
it engages in the angle transmission hole (Fig.
9.B, Fig. 10.B) and locks rotation.
4. Fit the sump (Fig. 9.F, Fig. 10.F) and tighten
the nut (Fig. 9.G, Fig. 10.G) fully anticlockwise
(25 Nm).
5. Remove the wrench (Fig. 9.E, Fig. 10.E) to
reset rotation.
4.5.4 Removing the 3-point, 4-point and
8-point blade and saw blade (if allowed)
Apply the guard to the blade.
1. Insert the wrench supplied (Fig. 9.E, Fig.
10.E) into the special hole, rotate the blade by
hand (Fig. 9.C, Fig. 10.C) and push the wrench
(Fig. 9.E, Fig. 10.E) until it engages in the
angle transmission hole (Fig. 9.B, Fig. 10.B)
and locks rotation.