O-Mac MS 2700, Руководство оператора

Страница: 46 / 88

46
4.2 Grip assembly
4.2.1 Assembly of the front hand grip
1. Position the cap (Fig. 3.A) by inserting the
pin (Fig. 3.A.1) into one of the holes available
on the transmission tube.
2. Fit the front grip complete with leg guard
barrier (Fig. 3.B) using the screws (Fig. 3.C),
taking care to keep the two anti-vibration
half-shells in place (Fig.3.D).
3. Fully tighten the screws (Fig. 3.C).
4.2.2 Fitting the handle bar- Type I
1. Unscrew the central knob (Fig. 4.A) and
remove the cap (Fig. 4.B).
2. Insert the handle bar (Fig. 4.C), making sure
that the controls are on the right.
3. Arrange the handle bar in the most
comfortable working position and lock it using
the cap (Fig. 4.B) and the knob (Fig. 4.A).
4. Hook up the control sheath (Fig. 4.D) to the
appropriate cable clamp (Fig. 4.E).
NOTE Loosen the knob (Fig. 4.A) in order to
rotate the handle bar and reduce its overall
dimensions for storage purposes.
4.2.3 Fitting the handle bar - Type II
1. Insert the handle (Fig. 5.A) into its seat in
the transmission tube (Fig. 5.B), making sure
that the controls are on the right.
2. Tighten and lock the knob (Fig. 5 C) on the
handle bar (Fig. 5 A).
4.3 Selecting the cutting means and
specific guard
Every cutting means must be fitted with
a specific guard, as indicated by the following
directions in the Technical Data table.
Choose the most suitable cutting means for
the job to be done, according to these general
in-structions:
• the cutting line head can eliminate tall
grass and non-woody vegetation near fences,
walls, foundations, pavements, around trees,
etc. or to completely clean a particular area
of the garden;
• the 3-point, 4- point and 8-point blades
are suitable for cutting brushwood and small
shrubs up to 2 cm in diameter;
• the saw blade (if allowed) is used to cut
wooden parts and fell small trees;
IMPORTANT Whenever you have to change
the cutting means, disassemble all its
elements.
4.4 Fitting the guard on the cutting means
Wear protective gloves.
4.4.1 Fitting the cutting means guard (wire
holder head, 3-point, 4-point and 8-point
blade)
1. Unscrew the screws (Fig. 6.A).
2. Position the guard (Fig. 6.C) in line with the
holes on the transmission (Fig. 6.B).
3. Secure the guard (Fig. 6.A) fully tightening
the screws (Fig. 6.C).
NOTE The cutting means guard (Fig. 1.E) has
the following symbol:
It indicates the rotation direction of