7
www.nxp.com
Start the application by pressing 1 -
“RUN” on the flip/flop (ON/OFF)
switch on the FreeMASTER control
page or by positioning the RUN/STOP
switch (SW1 on the Power Stage
board) to the RUN position (transition
from STOP to RUN in case the switch
was in the RUN state when a fault
event occurred)
Application Control
(part 5/8)
Enter the required speed by assigning
this value to the “
Nreq
” variable in the
variables watch window. The value is
in revolutions per minute.
Alternatively, the rotor speed can be
increased/decreased by pressing the
UP/DOWN switches on the Power
Stage Board
– SW2/SW3
respectively.
Application Control
(part 6/8)
11
12
STEP-BY-STEP INSTRUCTIONS (cont.)
Stop the application by pressing 0 -
“STOP” on the flip/flop (ON/OFF)
switch on the FreeMASTER control
page, or by positioning the RUN/ STOP
switch (SW1 on the Power Stage
board) to the STOP position.
Application Control
(part 7/8)
RESET the application anytime by
pressing the SW1 on the
MPC5744P controller board.
Application Control
(part 8/8)
13
14
