Nu-Link-Gang
Dec. 23, 2019
Page
25
of 37
Rev 1.00
NU
-LINK
-GA
NG
USE
R MA
NU
AL
5
NU-LINK-GANG
PROGRAMMER
SETUP
FOR
AUTOMATIC
IC
PROGRAMMING SYSTEM
5.1
Software and Hardware Setup
Follow section 3.1 and 3.3 to setup the programming voltage and firmware image file for four
programming units individually. Switch the programming mode to single-start.
5.1.1 Connection
Each programming units connects to the automatic IC programming system through individual slot and
the control bus as Figure 5-1.
(Left side)
Slot Pin Description
(Right side)
Control Bus Pin Description
A
A
B
B
Figure 5-1 Automatic IC Programming System Connection
