Nu-Link-Gang
Dec. 23, 2019
Page
19
of 37
Rev 1.00
NU
-LINK
-GA
NG
USE
R MA
NU
AL
4
NU-LINK-GANG PROGRAMMER SETUP FOR NUC505 SERIES
4.1
Choose the Programming Voltage
The Nu-Link-Gang supports three kinds of programming voltage, 1.8 V, 3.3 V, or 5.0 V. Users can
choose different programming voltage for each programming unit by setting corresponding
programming voltage switch. Please sets the programming voltage before the Nu-Link-Gang power
on.
4.2
Set the Programming Mode
Switch the programming mode to single-start or all-start.
4.3
Connect to the Target Chip
4.3.1 Nuvoton NUC505 ICP Gang Adapter
Connect the Nuvoton NUC505 ICP Gang Adapter to Nu-Link-Gang as Figure 4-1. Put the target chip
into the socket. Pin 1 is on the bottom-right hand side, marked in white arrow.
Figure 4-1 Nuvoton NUC505 ICP Gang Adapter with Nu-Link-Gang
