Nuvico CT-2M-MP20FH, Инструкция по эксплуатации

Страница: 17 / 40

17
2
3
5. Select
“
MODE
” and “
SPEED
”.
6. Select
“
START ANGLE
”. Hold down the
key while selecting the start position using the
Joystick . Current panning position will be displayed. Release the key to complete the
selection of the start position. Or press the
the desired position and the zoom position. key then the
“CONTROL” displays. Move
ey then the
“CONTROL”
disappears. To adjust at the 0.1 degree interval, twist the
field. at the pan field and the tilt
7. Select
“
END ANGLE
”. Hold down the
key while moving the to select the end
position. The end position angle should be larger than start position. Release the key to
complete the selection of the end position. Or press the key then the
“CONTROL”
displays. Move the desired position and the zoom position. Press the IRIS Close key then the
“CONTROL” disappears. To adjust at the 0.1 degree interval, twist the
Joystick at the pan field
and the tilt field.
8. Set
“
SCAN DIR
” to CCW or CW.
9. Select
“
SWAP
”, Set to ON to exchange the start angle and the end angle.
10. Set
“
DWELL time
”.
11. Select
“
SAVE AND EXIT
” and push the
to the right or press the key.
Press the ESC or IRIS Close key to exit the program without saving.
NOTE: Pressing the key delete stored data at the angle field.
To set the position using the Preset position:
a. Before entering the Auto Scan menu, select a Preset position as a starting point for Auto Scan.
Example: +
keys and do step 1 to 5. In step 6, just press the key at the start
angle position, the current position will be displayed as a start position.
b. Save and Exit from the menu.
c. In normal mode, call a Preset to be the end point of Scan. Press + keys then press the
SCAN key to enter the Auto Scan menu. Move the cursor position to END ANGLE. Just press
the CTRL key at the end angle position. Save and exit from the menu.
Press the
as below.
key on the angle field to display with the small OSD. Then the screen will show
The setting procedure is the same as above.
NOTE: 09: AUTO-PAN mode (endless panning)
AUTO SCAN AREA SETUP
(CTRL KEY)
NUMBER 01
START : ----- -----
END : ----- -----
EXIT(ESC TO EXIT)
CTRL
CTRL
IRIS Open
Press the IRIS Close k
Joystick
CTRL Joystick
CTRL
IRIS Open
Joystick IRIS Open
HOME
PRST CTRL
PRST
SCAN