Nuvap N2Health Manual
Ver 1.7
6
Wait for the light guide on the top of the device (see the picture) to switch on.
When the blue light turns on, open the application on the mobile device and
select the item "add device" from the "Device Management" menu. (Attention: If
the indicator light emits a green light, perform the "Reset" procedure. When the
indicator is red, contact Nuvap technical support).
The application will guide the user through the configuration procedure. At the end, a green light signal will
be emitted. If the procedure is not successful, the light signal will be yellow. In this case, consult the
“Sound and light signals” section of this manual.
6.
Device Reset
To be configured, the device must be in "waiting for configuration" state. If it is not (or if it is necessary to
change the parameters of the WiFi network), it is necessary to reset the device through the following
procedure:
-
If already powered, turn the device off and on again using the power button
-
Wait 2 minutes for the device to activate the features
-
With the palm of your hand, press the touch button and keep
it pressed for 15 seconds (picture).
-
When the blue light guide is turned on, release the touch
button.
-
When the light guide flashes blue, it shows that it is in the
“configuration waiting” state. To avoid inadvertent resets, this
option is automatically disabled 1 hour after switching on.
7.
Sound and light notifications
Light notification:
-
blue light flashing every 5 seconds: waiting for user device configuration
-
green light on for 2 seconds: device configuration notification
-
green light turns on for 0.5 seconds: start of measurement cycle
-
yellow light flashing for 0.5 seconds: generic error and / or no connection to the internet. Check the
correct functioning of the WiFi hotspot or SIM mobile network
-
5 yellow light flashes of 0.5 seconds each: wrong WiFi network password, re-configure the device
-
Red light: fatal error, contact Nuvap support
