Nuvap N2Health Manual
Ver 1.7
7
LED signals:
-
steady light: device powered
-
intermittent flashing for 3 seconds: device startup procedure
Sound notification:
-
0.5 second tone emission: low battery. Connect to the mains and wait for complete charging. If the
battery is completely discharged, it takes at least 4 hours to fully charge. Warning: if the battery of the
device is completely discharged, the device does not perform measurements and does not transmit
data to the platform during the recharging phase.
8.
Maintenance
The device does not require software maintenance, all software updates are automatic, remotely
managed by Nuvap that keeps the device updated to the latest firmware version. Remote maintenance
is a service provided by Nuvap. Please refer to your sales representative for more information about this
service.
For each device, the calibration certificate issued by the manufacturer may be requested, by sending an
email to [email protected] indicating the MAC and serial number - SN - indicated on the label on
the back of the device.
Cleaning the device requires a few steps:
-
Unplug the power cord before starting cleaning.
-
Use a clean sponge or an antistatic cloth wet with a non-abrasive solution and a few drops of warm
water.
-
Dry with a soft cloth and reconnect the device to the mains.
-
Do not wet the device directly and do not use detergents on the surface to avoid electric shock and
damage.
9.
Disposal
Do not throw the device in the waste bin. The product has been designed to allow an appropriate use of the
components and the recycling of materials. Be sure to dispose of or recycle your device in accordance with
local laws and regulations regarding the disposal of electronic products.
