Nuvap N2Health Manual
Ver 1.7
5
4.
Device installation
The Nuvap N2Health device operates in indoor environments with temperatures between -5 and +40 ° C and
a relative humidity level between 20% and 80%.
The device can be desktop mounted and its installation simply requires its positioning on a flat surface,
between 1.1 and 1.7 m above the floor, in places where occupants usually stay.
The device must be positioned at least 1 meter at least 1 m away from electromagnetic sources (electronic
equipment), doors, windows and air / exhaust vents.
5.
Device configuration
Once installed, the device must be powered and configured on the Nuvap cloud platform. Make sure you have
all the required items to set up the connection, depending on the mode you choose:
-
Configuration with WiFi connectivity: have the SSID name and WiFi authentication password. The
device supports the types of WiFi networks indicated in the 'The Device' section of this manual.
-
Configuration with mobile connectivity: the SIM is supplied pre-installed by Nuvap, during the
configuration phase you will be asked to enter the APN name (iot.1nce.com).
For the configuration it is necessary to be equipped with a smartphone with integrated camera and BTLE
connectivity (bluethooth).
Before proceeding with the configuration, make sure you have a Nuvap account and the Nuvap application
installed on your mobile device. Otherwise, download the application and register your account following the
wizard.
In order to configure the device proceed with the following steps:
Connect the device to the mains via the supplied power supply and switch
on the power button as shown in the picture. (Warning: if the device emits a
short tone (half a second) it means that the battery is low. Leave the device
switched on and connected to the mains for at least 4 hours and then repeat
the procedure).
