Nuvair Open Electric Models
Nuvair Page 17
www.Nuvair.com
a
6.2
Electrical Connection
•
Please read all information supplied before Connecting Electricity to the Compressor System.
•
You should hire a licensed electrician to install any electric compressors purchased from Nuvair.
•
The compressor is delivered with raw leads ready to be installed into a junction box.
•
In the event a plug is needed, Nuvair recommends that the licensed electrician doing the install
determines the plug necessary.
•
Make sure your electrician follows approved and compliant standards
for your location.
7.0
Checks to be run at the start of each working day
Inspect the exterior of the compressor (couplings, pipes, pneumatic
components etc.) and check for any oil leaks. Replace parts where
necessary or contact
Nuvair
.
7.1
Lubricating oil level check
Check that the level of lubricating oil
(a)
is within acceptable limits (i.e.
between min. and max.). Note that an excessive quantity of oil can leave
deposits on the valves while too low a level prevents proper lubrication and could cause engine
seizure. If the oil level is not within the minimum and maximum limits top up or drain as described in
section 11.8 Changing the lubricating oil and filter”.
7.2
Check that the refill hoses are in good condition
Inspect the refill hoses and make sure there are no cuts, holes,
abrasions, leaks etc. If necessary replace with new hoses.
7.3
Storing technical documentation
The use and maintenance manual and its appendices must be stored
carefully and must always be kept where they can be accessed easily
for immediate review.
This User Manual contains important safety information and should always be available to
those personnel operating this equipment. Read, understand, and retain all instructions
before operating this equipment to prevent injury or equipment damage.
