Nuvair Coltri MCH 36 Electric, Руководство пользователя

Страница: 26 / 40

MCH36 Open Diesel (Kubota)
www.nuvair.com Page | 24 MCH36 Open Diesel (Kubota)
Recommended Nitrox compressor lubricant is changed when the first 25 hours of use is
reached, then change lubricant in 100 hour cycles or annually.
Wear gloves when handling compressor lubricant. If contact with skin is made, wash the
skin surface with soap and water.
Always wear goggles when handling compressor lubricant. These materials can cause eye
irritation. If you accidentally get lubricant into your eyes, flush with fresh water for 15
minutes and contact a physician if irritation develops.
Compressor lubricant should be incinerated after use in a licensed facility in accordance
with Federal, State, and local regulations.
11.8 Changing the lubricating oil and filter
The lubricating oil must be changed every 250 working hours
or annually. Every time the lubricating oil is changed the oil
filter must be changed too. To change the oil continue as
described:
•
Position a recipient under the drain tap ( a ) so that the oil
flows into the exhausted oil recipient (recipient capacity of
at least 1.3 gallons or 5 liters required).
•
Open the oil fill plug ( g ).
•
Open the plug ( a ) and let all the oil flow out.
•
Unscrew the fittings ( c ) and remove the pipe ( b ).
•
Remove the fixing screws ( e ) and the cover ( d ).
•
Replace the filter ( f ) with a new one.
•
Re-close the plug ( d ) with the screws ( e ).
•
Put the pipe ( b ) back and tighten the fittings ( c ).
•
Close the drain tap ( a ). -remove the fill plug ( g ).
•
Fill the oil sump with 1.3 gallons or 5 liters of oil from top oil
plug
•
Close the oil fill plug ( g ).
•
Switch on the compressor and run it depressurized for 30
seconds.
•
Switch off the compressor and remove the plug from the
mains socket.
•
Check the oil level ( h ); if it is not between the min. and max. lines proceed with the tasks
described in paragraph “11.7 Checking the oil level”.