Nussbaum UNI-LIFT 5000 CLT PLUS, Инструкция по эксплуатации и документация

Страница: 33 / 56

Operating Instruction and Documentation
UNI-LIFT 5000 CLT / Plus
- 33 -
goes to the top edge of the floor. For an existing concrete floor the dowels have to be
chosen according to pic. 8. If floor tiles are on the concrete floor, the dowels have to
be chosen according pic. 9. Its important for the trouble-free working that the base
plates are clean and the guides of the sliding block are clean and greased.
Check the adjustment of the base plates and dowel the lift: Bore the holes to fix the
dowels through the borings of the base plates. Clean the holes with pressure air. Put
in the safety dowels.
22.Dowel the operating unit.
23. Fine adjustment of the lift: first one base plate, than the second base plate. If there is
an uneven floor even it with metal sheets. A continuous contact between the floor
and the base plate must be guaranteed to avoid hollow spaces.
24.Tighten the Liebig-dowels with the dynamometric key (M = 80Nm).
Each dowel must be tightened with the demanded torque. Otherwise the normal
function of the lift can not be guaranteed.
Observe the regulations of other dowel-manufacturers.
25. Raise and lower the lift several times with load. Check the torque of the dowels and
check the hydraulic parts for tightness.
26. Mount the covers: Do not damage the cables.
27. The lift has now its normal function
When there are disturbances, the customer service has to be called!
9.4 Initiation
Before the initiation a security check must be performed. Therefore use form: First
security check.
If the lift is installed by a competent person, he will perform this security check. If
the operator installs the lift by himself, he has to instruct a competent person to
perform the security check.
The competent confirms the faultless function of the lift in the installation record and
form for the security check and allows the lift to be used.
Please send the filled installation record to the manufacturer after the
installation.