A
Ensure all fasteners (bolts/washers) are securely tightened and
all chair parts have been assembled correctly (Refer back to
Assembly Instructions if needed. Contact Nuprodx, Inc. if unsure
of anything).
B Commode Chair
: Position the multiCHAIR over the toilet, so
that the center of the commode opening is directly above the cen-
ter of the toilet bowl. Adjust the height of the multiCHAIR accord-
ingly by setting the position of the brass buttons on the four inner
legs to the various adjustment holes on the outer legs.
C Shower Chair
: Position the multiCHAIR inside the
bathtub/shower. Adjust the height of the multiCHAIR accordingly
by setting the position of the brass buttons on the four inner legs
to the various adjustment holes on the outer legs (Refer to Figure
8). Pull the release latch open on the slider seat frame and trans-
fer into the tub portion until the latch engages onto the opposite
stop (Refer to Figure 9).
OPERATING INSTRUCTIONS
Figure 8
SAFETY PRECAUTION!
Ensure that the height of each inner leg is set to make the
multiCHAIR level. If this is not properly done, the multiCHAIR
could tip to one side causing the user to fall. This could result in
serious injury or even death!
ADDITIONAL SAFETY PRECAUTIONS
!ATTENTION: PLEASE READ!
WARNING! Failure to account for the afformentioned and the following safety precautions can result in seri-
ous injury to the user or even death!
Figure 11
Figure 10
A
Leg Height Adjustment: When making height adjust-
ments to any of the legs, make sure that the brass but-
tons are fully engaged into the outer legs. If pushed too
hard the button could become stuck inside the inner leg
(Contact Nuprodx, Inc. if this occurs). Leg height adjust-
ment should only be made before transferring the user
into the chair (Refer to Figure 10).
B
Crutch Tips: Before transferring into and out of the
chair, all four crutch tips must be securely planted onto
the floor. Failure to do so could cause the chair to
become unstable.
C
Fasteners: Over time the screws and washers on the
chair may become loose. It is very important that these
are checked and securely tightened before each use.
Failure to do so could cause a part to dislodge from the
chair (Refer to Figure 11).
- PAGE 3 -
Figure 9
