multiCHAIR 5100tx
!ATTENTION: PLEASE READ!
ASSEMBLY INSTRUCTIONS
Please see Page 6: LIMITED WARRANTY of these instructions. If the warranty is not acceptable, contact Nuprodx, Inc. for infor-
mation about returning the chair for a refund (Restocking fees and shipping charges will be applied). This chair is designed and
intended for indoor shower and bathroom use. It is not designed for outdoor use and will void the warranty if used in this fashion. If
thresholds, shower curbs or barriers are encountered that exceed ½” in height, the area in question should be brought within the
code for disabled accessibility.
- PAGE 1 -
Figure 1
A
The multiCHAIR 5100tx is shown in Figure 1.
B
Unpack all parts from the shipping carton. Remove all tape
and/or packing from the chair. Keep shipping materials for future
use. Note the location of padding materials and sheet-plastic which
protects parts of your chair.
C
Open the seat frame, lock the slide bolts, and
position the frame upside down (Refer to Figures 2 & 3).
D
Position the legs so that the brass buttons point outward (Making
it easier for future leg height adjustment). Make sure that the legs
slide “home” into the socket of the seat frame. Use the included ¼”
Allen wrench to securely tighten the bolts located at the corners of
the frame (Refer to Figure 4).
SAFETY PRECAUTION!
If any of the legs are not fitted correctly into the socket of the seat
frame or are not securely tightened there is an extreme risk of the
legs dislodging completely from the chair. This could cause seri-
ous injury or even death!
Figure 2
Figure 4
slide bolts
Figure 3
slide bolt
