Gb - 26
To activate this push button, use a pointed object such as a pencil tip.
The mode is changed by pressing and holding the push button: a number of beeps (from
1 to 8) is then emitted by the collar.
Keep the button pushed in to run through the modes. Release once the desired mode is
reached: the collar memorises the configuration you select.
The table below shows how the
CANIFUGUE
operates in each mode:
Mode
Nr
Stimulation level
of beeps
Very low
(small dog or dog with
sensitive temperament)
Medium
(medium dog or
dog with normal temperament)
Very strong
(large dog or dog
with difficult temperament)
NB:
your
CANIFUGUE
has been set at
Mode 4
in the factory. Before using the system,
adjust this setting according to your dog sensibility.
Three functions safety system:
1) Breakage of antenna wire:
If the antenna wire breaks (or the connection fails), the transmitter alerts you to this
operating fault with a beep.
2) Leaving the warning zone:
After 20 seconds (approx.) of continuous presence in the warning zone, your dog will be
signalled to leave the zone by the emission of a few short stimulations.
3) Leaving the stimulation zone:
If your dog remains immobile in the stimulation zone for approximately 20 seconds, the
system stops emitting corrective stimulations. The stimulation cycle resumes when your
dog leaves this zone.
Replacing the battery of the collar
Unscrew the 4 screws on the battery cover and remove the old battery with the tab
provided. Insert the new battery in the position indicated on the plastic casing. A beep is
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8