Gb - 23
Switching On/Off
Switching On:
• The transmitter
Switch the transmitter to the On position using the switch button on the left side of the
unit: a green indicator light will come on (cf. Diagram No. 1).
•
The collar
Fitting the battery:
Unscrew the 4 screws on the battery cover (cf. Diagram No. 2), insert
the battery (CR2) in the position indicated on the battery housing. A beep sounds, indicates
that the collar is switched on.
Check that the seal is in place on the groove of the battery cover.
Before re-tightening the 4 screws, force the strap against the battery cover by pulling it.
Using a screwdriver, moderately tighten the 4 screws.
Switching Off:
If the control collar is not to be used for a long period, the battery should be removed from
its housing. There is a tab to assist with battery removal. If you want to take your dog off
the property, you are advised to remove the receiver collar. You can also switch the
transmitter to Off and the green indicator light will go out (cf. Diagram No. 1).
AUTOMATIC SYSTEM
As soon as the animal wearing the
collar enters the protected area, he is
warned by a beep. If he continues
to move forward, towards the
perimeter wire he receives stimulations.
The wire is placed on the ground,
buried or raised on an existing fence.
For the system to function, the wire
must form an uninterrupted loop.
Both wires must be spaced 2 meters
apart.
Diagram No. 4:
sample installation
By twisting the outward strand with the inward strand, wave
emission is blocked and the animal can move freely within
this zone.
Warning beep
area
Stimulation
area
Antenna wire
Twisted wire
Transmitter unit
2 m between
both wires