Numatic FloorCare TGB 1840, Руководство по устранению неполадок и помощи

Страница: 4 / 9

Operating Switches
Index page...
Whilst the brush motor is running press the water flow On / Off Button for fluid control (Fig.C), the clean water On / Off tap must
be open.
Ideally set the tap to 450 this enables the cleaning solution to last the same time as a fully-charged battery.
When the Triggers are released the brush motor and the cleaning solution pump will switch off, the vacuum motor will continue
for 10 seconds.
Press the mode select button to operate the brush only (Fig.D).
The start sequence is required in this mode.
The water flow On / Off button will operate in this mode.
Press the mode select button again to get vacuum only.
The On / Off Switch and triggers are not required in this mode. (Fig.E)
Press the mode select button to switch this mode off and return to default mode.
The panel if unused will automatically turn off after 60 seconds.
C
D
E
The brush motor will cut out and the brush load light will flash if the brush motor has been overloaded (Fig.F).
Releasing the handle triggers will allow the machine to reset.
Brush Overload
F
IMPORTANT
If the brush motor keeps overloading consider using a different type of brush.
Heavy brush load decreases the available battery run time.
! !
Fitting Brush - Floor Tool, Filling Machine, Fill Gauge, Moving Water Flow Adjustment, Raising the Floor Tool Operating Switches
Draining Top Tank, Draining Bottom Tank, Clean Water Filter Clean Separator Changing the Floor Tool Blades Charging (Cont) Removing Battery, Fuse, Charging