Fitting Brush - Floor Tool, Filling machine, Fill Gauge, Moving...
Fitting the brush...
The machine uses a 400mm brush or a
360mm pad drive.
Filling tank...
Fill the clean water tank to a maximum
of 18 litres including chemical if required.
Fill gauge...
Fitted to the clean water inlet is a red
plastic fill gauge, this rises as the tank
fills.
Moving when full...
When the clean water tank is full the machine
can be tilted to a maximum of 45
0
without
spillage.
Take care to make sure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the clean water tank.
Fitting the Floor Tool...
Make sure the inspection cap is in place on the
fluid pipe.
Swing the floor-tool carrier to the side of the
machine.
Secure to the carrier using the two knobs fitted
to the floor-tool carrier
Do not over tighten the retaining knobs.
Fit the brush pad onto the Nulock drive
and twist to lock in place.
Saftey Gloves are recommended for
changing used brushes.
Remove the filler cap and fill using a hose,
bucket or suitable container.
Fitting Brush - Floor Tool, Filling Machine, Fill Gauge, Moving
Water Flow Adjustment, Raising the Floor Tool
Draining Top Tank, Draining Bottom Tank, Clean Water Filter
