PICNV IDVP50 - 9
en
MICROWAVE STEAM STERILIZER
Contents or parts
a. Domed cover (lid)
b. Bottle rack and handle
c. Base
1. Wash with a mild soap and rinse all parts thoroughly
2. Take the cover and the bottle rack out of the sterilizer
3. Pour 200ml of water into the centre reservoir (see illustration 2)
4. Return the bottle rack in the base. Load as follows:
Place neck of bottles onto marked circles allowing them to stand upright. Place screw rings over the centre handle. Place
silicone nipples, spouts or sport straws in the areas provided with the illustration: (see illustration 3)
5. Close the sterilizer with the lid making sure the knob on top is turned to ‘OPEN’, before placing in microwave.
6. Place the sterilizer on the turntable of the microwave
7. Warm up: - with a microwave rated 475-850W: 8 minutes. – with a microwave rated 850-1000W (maximum force) for 6
minutes. Not a minute longer!
8. AFTER MICROWAVING
Caution: To avoid injuries wait for at least 2 minutes before taking out the bottles.
When removing Steriliser from microwave make sure to only pick it up on the sides of the sterilizer. Place sterilizer on a heat
resistant surface. Remove the lid by lifting the clips, located at the sides of the sterilizer. Lift lid cover so that the opposite
side -from the side you’re on- opens first. Allowing steam to escape from you.
In case you want to use the bottles immediately; turn the knob of the cover to ‘OPEN’ so that the steam can escape. Assemble the
bottles to keep them sterile inside.
REMARK: The content of the sterilizer stays sterile /- 3 hours when the cover has not been opened and the knob stayed
in ‘CLOSE’ position.
9. CARE AND CLEANING
Drain excess water from sterilizer. Clean and rinse thoroughly after every use. This will prevent limescale build up. Store when
completely dry. The sterilizer is Dishwasher safe.
SOME IMPORTANT REMARKS:
- Do not overload sterilizer – follow loading instructions
- Allow sterilizer at least 2 minutes of standing time at the end of the cycle before removing from the microwave.
- Use caution when removing lid as steam will be escaping and may cause injury.
- Keep all parts of the steriliser out of the reach of all small children, especially after use.
- Make sure all items you want to sterilize are suitable for microwave use. A microwave doesn’t stand metal pieces. Some
synthetics can contain metal pieces. When in doubt, we advise you to consult the producer.
- When using in combination ovens, make sure sterilizer is not heated by grill, and oven has cooled before use.
- Always put the sterilizer upright so that the water can’t flow over.
- When sterilizing breast pumps – place all parts, which are claimed suitable for microwave use, into the water in the center
reservoir.
- This article is suitable for use in microwaves rated 475-1100Watt.
NEVER use glass bottles in this steam sterilizer – this can cause deformation and breaking of both the sterilizer and the bottles.
This appliance is not under warrantee when instructions above are not followed
PP BOTTLES
This bottle/cup is made of clear polypropylene. CLEANING : To ensure hygiene: before first use place in boiling water for 5 minutes. Clean
all parts before and after each use. Wash in dishwasher (top rack only) or in warm water with a mild soap. Rinse thoroughly. DO NOT
sterilize bottles/cups in sterilizer that is only made for glass bottles. Don’t use a scourer to clean the bottle/cup. For your child’s safety
and health: WARNING! : Always use this product with adult supervision. Accidents have occurred when babies have been left alone
while drinking equipment due to the baby falling or if the product has been disassembled. Continuous and prolonged sucking of fluids
will cause tooth decay. Young children can suffer from tooth decay even if they drink non-sweetened drinks. It can appear if the baby is
permitted to use the bottle/cup during long periods of day- or more particularly night-time, when saliva flux is reduced, or if the nipple/
spout is used as a pacifier. Never use feeding teats as a pacifier. Test the nipples/spouts before each use by pulling in all directions.
Discard nipples/spouts from the moment they start showing signs of damage (enlargement, cracks). Do not expose nipples/spouts to
sunbeams or other heat sources. Do not leave nipples/spouts in a disinfectant product for longer than necessary (follow instructions on
disinfectant). Keep all components not in use out of the reach of children. INSTRUCTIONS FOR USE : Fill the bottle/cup & warm up in mi-
crowave with nipple/spout removed. Do not let the liquid boil or become too hot to avoid risk of burning. Heating in a microwave oven
may produce localised high temperatures. Roll the bottle/cup between hand palms after warmining up to distribute the heat evenly and
test temperature before feeding. Do not heat in oven or a bottle-warmer for glass bottles. Do not use for carbonated drinks. Keep this
information. www.nubyclub.com - Valid norm: EN14350
