9.1 Cleaning
9.1.1 Cleaning of the device
Switch off the device and disconnect it from the power supply.The apparatus can be
cleaned with a damp cloth. Use lukewarm water and a non-abrasive liquid household
cleaner (no abrasive, no alcohol content solution). If a more sterile cleaning is needed,
use a cloth moistened with an antimicrobial cleaner.
CAUTION:
Do not submerse the apparatus in liquids. Should the unit accidentally become sub-
mersed, contact the dealer or Authorized Service center immediately .Do not attempt to
use a system that has been wet inside until inspected and tested by a Service Technician
Certified by Authorized Service center . Do not allow liquids to enter the ventilation
holes.
9.1.2 Cleaning of display panel
Use a soft and dry cotton cloth or micro fiber tissue to clean the panel. To remove
fingerprints or grease, use a non-abrasive glass cleaning agent. Apply a small amount
of the cleaning agent to a soft cotton cloth and then carefully clean the panel.
CAUTION:
Do not spray the cleaning agent directly on the glass panel.
Do not use cleaning agents that contain strong alkalis, lye, acid, detergents with
fluoride or detergents with ammonia.
9.1.3 Cleaning the electrodes
Apply the protective backing to the tacky side of the electrode. Place the electrode
on the side of the protective backing that is labeled with the word on.
It may be helpful to improve repeated application by spreading a few drops of
cold water over the adhesive and turn the surface up to air dry . Over Saturation
with water will reduce the adhesive properties.
Between uses, store the electrodes in the reusable bag in a cool dry place.
9. Maintenance and Troubleshooting
65
Rehab-Series
