NTI Trinity Lx 150, Инструкция по установке и эксплуатации

Страница: 88 / 104

Trinity Lx
│
Installation and Operation Instructions Lx Series
88
Table 17-3 Hold and Lockout Codes
Code Description Note
8
Internal fault: Zero crossing not detected Hold
9
Internal fault: Flame bias out of range Hold
10
Internal fault: Invalid Burner control state Lockout
11
Internal fault: Invalid Burner control state flag Lockout
12
Internal fault: Safety relay drive cap short Hold
13
Internal fault: PII shorted to ILK Hold / Lockout
14
Internal fault: HFS shorted to LCI Hold / Lockout
15
Internal fault: Safety relay test failed due to feedback ON Lockout
16
Internal fault: Safety relay test failed due to safety relay OFF Lockout
17
Internal fault: Safety relay test failed due to safety relay not OFF Lockout
18
Internal fault: Safety relay test failed due to feedback not ON Lockout
19
Internal fault: Safety RAM write Lockout
20
Internal fault: Flame ripple and overflow Hold
21
Internal fault: Flame number of sample mismatch Hold
22
Internal fault: Flame bias out of range Hold
23
Internal fault: Bias changed since heating cycle starts Hold
24
Internal fault: Spark voltage stuck low or high Hold
25
Internal fault: Spark voltage changed too much during flame sensing time Hold
26
Internal fault: Static flame ripple Hold
27
Internal fault: Flame rod shorted to ground detected Hold
28
Internal fault: A/D linearity test fails Hold
29
Internal fault: Flame bias cannot be set in range Hold
30
Internal fault: Flame bias shorted to adjacent pin Hold
31
Internal fault: SLO electronics unknown error Hold
32
Internal fault: Safety Key 0 Lockout
33
Internal fault: Safety Key 1 Lockout
34
Internal fault: Safety Key 2 Lockout
35
Internal fault: Safety Key 3 Lockout
36
Internal fault: Safety Key 4 Lockout
37
Internal fault: Safety Key 5 Lockout
38
Internal fault: Safety Key 6 Lockout
39
Internal fault: Safety Key 7 Lockout
40
Internal fault: Safety Key 8 Lockout
41
Internal fault: Safety Key 9 Lockout
42
Internal fault: Safety Key 10 Lockout
43
Internal fault: Safety Key 11 Lockout
44
Internal fault: Safety Key 12 Lockout
45
Internal fault: Safety Key 13 Lockout
46
Internal fault: Safety Key 14 Lockout
47
Flame rod to ground leakage Hold
48
Static flame (not flickering) Hold
49
24VAC voltage low/high Hold
50
Modulation fault Hold
51
Pump fault Hold
52
Motor tachometer fault Hold
53
AC inputs phase reversed Lockout
54
Safety GVT model ID doesn’t match application’s model ID
Lockout
55
Application configuration data block CRC errors Lockout
56-57
RESERVED