Fig. 4
8
9
(1) Charge (if batteries are used)
1) Insert the AC Adaptor plug into a power supply.
2) The AC IN lamp lights in green.
3) The internal microcomputer checks the voltage of the batteries and starts charging, if necessary. If it starts charging, the
CHARGE lamp lights, and the mark of the remaining amount of the batteries on the LCD panel will be animated.
* There is no need to turn on the power.
4) When the CHARGE lamp turns off, charging has been completed.
5. HOW TO USE
(1) Connecting Motor Handpiece
Align the mark of the Motor Handpiece Cord Plug of the
motor handpiece with the mark of the motor handpiece
connector and insert the plug until it locks. (Fig. 3)
(2) Connecting AC Adaptor
Insert the jack of the AC Adaptor into the power connector
with the mark of the jack cast down. (Fig. 4)
(3) Connecting Foot Control (Option)
Securely insert the plug of the Foot Control (Option) into the
Foot Control Connector with the mark of the plug cast
down. (Fig. 5)
* You do not have to connect the Foot Control, if you intend
to use this product without the Foot Control.
4. HOW TO CONNECT EACH PART
• Do not connect other than AC120V or AC 230V. If it connects to others, it may cause a malfunction.
• Since the AC IN lamp lights to indicate that the supply power is on, it does not go out even after a charge is
completed. See the CHARGE lamp to check the charging conditions.
• The charging normally takes approx. 5 hours, but it depends on battery use conditions. Older batteries are
especially prone to significantly shorter charging and operating times.
• The temperature of the batteries is measured during charging. Proper charging cannot be preformed if the
charger is placed in an environment which is subject to sharp temperature change (next to window, subject to
direct sunlight, near air outlet or fan heater). Place it in a place where temperature change is minimal.
• Charging may not be started in the following case:
•
The temperature of a battery is too low or too high. (less than 0°C (32°F) or more than 40°C (104°F). )
•
The temperature of the batteries is executively high or low. (Lower than apporox. 0 degree or higher than
approx. 40 degree)
•
A battery is not connected.
•
The voltage of a battery is abnormal. (See P.16 10. “ERROR CODE”)
• Batteries are automatically charged depending on conditions, even when the power is on. But when the motor
handpiece is used, charging is suspended to protect the battery.
CAUTION
To remove the plug, hold the plug ring and pull it out.
NOTICE
• Bar Display
LCD
It displays the bar graph which shows the degree of load applied to the motor while
the file is in motion.
Fig. 3
Fig. 5
Foot Control (option) Plug
Foot Control (option) Plug
Foot Control Connector
Foot Control Connector
Fig. 6
AC IN Lamp
AC IN Lamp
REVERSE Key
REVERSE Key
CHARGE Lamp
CHARGE Lamp
AUTO REVERSE Key
AUTO REVERSE Key
POWER Key
POWER Key
MEMORIZE Key
MEMORIZE Key
GEAR RATIO Key
GEAR RATIO Key
SPEED Key
SPEED Key
TORQUE Key
TORQUE Key
PROGRAM Key
PROGRAM Key
Motor Handpiece
Cord Plug
Motor Handpiece
Cord Plug
Motor Handpiece Connector
Motor Handpiece Connector
Ring
Jack of the AC Adaptor
Jack of the AC Adaptor
Power Connector
Power Connector
