02/17 Rev. 02
SERVICE MANUAL
Attachment, Setup, Service
Rewinder
2000
2
General Notes
Intended Purpose
The option “Rewinder 2000” (subsequently referred to as the rewinder) is a
peripheral device for label printers of the types TTK, TTX 350, 64-xx,
AP 5.x, AP 7.t and XLP 50x. The device is designed for winding up label
material after it has been printed using one of the printer types named
above.
Properties
The rewinder is permanently attached to the printer. The printer provides
power for the rewinder motor via a socket on the front, which is also used
for receiving signals relating to the lateral deflection of the bouncer arm.
Rotational speed
While the material is being wound up, the rotational speed is controlled via
the lateral deflection of the bouncer arm. The greater the lateral deflection,
the lower the rotational speed. If the label material sags – the bouncer arm
is in this case only slightly deflected – the rewinder increases the rotational
speed in order to make up the "delay". This ensures that the label material
is rolled up evenly tautly. Without lateral deflection - e.g. when the material
is finished – the rewinding process stops after about four seconds.
Direction of rotation
The label material can be alternately rolled up with the labels facing
outwards or inwards by reversing the direction of rotation.
