SF200 Manual
SF200E-0160-01 REV 03
Diane Smith
4/15/13
Page 14 of 27
4.4.2
Power connections. Connect the SF-200 Power Adapter
cable from the Surge Suppressor to the DC 12V input on the
SF-200. The Monitor should also be plugged into the Surge
Suppressor.
Contact Noventri for all your accessory purchases
1-301-790-0103
www.noventri.com
4.4.3
If you plan on using your SF-200 as a networked player,
connect it’s LAN to your Local Network using an Ethernet
cable.
Contact Noventri for all your accessory purchases
1-301-790-0103
www.noventri.com
Note:
If you plan on installing multiple SF-200 players to your
Ethernet network it is best at the very beginning to connect
only one player at a time. This can be done by powering
them all up and making their Network connections one at a
time, or by having them all connected to the network and
powering up only one player at time. This is to verify that
they are properly being assigned IP Addresses.
If they boot up to display the default IP Address
192.168.0.190, you must correct it’s IP Address before
connecting the next player.
(See the
Network Usage
section of this manual)
4.4.4
If you plan on using your SF-200 as a stand-alone
(Sneakernet) player, the Ethernet cable is not necessary.
4.4.5
If you will be using your SF-200 as a networked player, verify
that the USB Drive is firmly inserted into one of the SF-200
USB ports.
If you will be using your SF-200 as a stand-alone
(Sneakernet) player, the USB Drive can be inserted at a later
time, after a project has been created and published to it.
Note:
The USB Drive MUST remain in the SF-200 for the player to
connect to the server or display content.
