SECTION III
PRIOR TO USE
EQUIPMENT OPERATION AND FILTER CARE INSTRUCTIONS
1. The Novatek Vacuum Shrouded Equipment has been specifically designed to clean up hazardous material such as
lead-based paint and asbestos. Special filters reduce the incidence of airborne dust that would be created by other
methods of cleaning.
2. During the removal of protective coatings, asbestos dust, and other hazardous materials, do not sweep, scoop,
shovel or in any manner handle other than by vacuuming.
3. Do not attempt, at any time, to bypass, remove, substitute, or by any other means, change the filters in this system
with non-original equipment manufacturer parts. Use only approved Novatek vacuum filters and filter bags. Before
attempting to use and before cleaning, be certain that you fully understand the instructions given for the setting up
or cleaning/changing of filters in this vacuum unit.
EQUIPMENT SET UP
Remove the vacuum unit and all the attachments from the carton. Do not use the system until this owner's manual has
been read and fully understood. Improper use could cause damage to the units or to the special filters employed.
BACK PACK FRAME/CANISTER ASSEMBLY (Models VA03ABK, VA03EBK)
The vacuum unit is shipped with the frame attached to the canister. Adjust the various straps to fit the operator as illustrated
and discussed below.
ADJUSTING HARNESS STRAPS TO THE OPERATOR:
1. Set the vacuum unit on a table with the frame to the table edge.
2. Loosen all straps; top and bottom.
3. Slip arms and shoulders through the shoulder and chest straps.
4. Close the waist straps and tighten.
5. Tighten the upper and lower adjustments of the shoulder and chest straps so that the shoulder pads come over the
shoulders but remain above the armpit.
6. Equalize the tension on each strap so that the frame is held level.
Содержание VA03ABK
Страница 1: ......
