Novatek VA03ABK, Руководство по эксплуатации и техническому обслуживанию, Страница: 8 / 19

REMOVAL OF CANISTER FROM BACK PACKS (Models VA03ABK, VA03EBK)
The back pack frame can be detached by removing the two speed pins from the attaching lugs, pulling the frame away from
the canister, and then lifting the vacuum unit up freeing it from the lower bracket of the frame.
Whenever the back pack frame has been removed from the canister, it should be remounted to the canister before the
vacuum unit can be used as a back pack.
REMOUNTING THE FRAME TO CANISTER (SEE ILLUSTRATION)
1. Set the canister on a table with the top frame brackets turned to the table edge.
2. Make sure the double rubber pads are on the canister under the top brackets and that a rubber pad is on the
bottom bracket of the frame.
3. Pick up the frame and catch the bottom of the canister with the bottom bracket.
4. Pull the frame up towards the canister, fitting the two top canister brackets through the second slots from the
bottom of the center frame mounting plate.
5. Push the frame onto the canis
ter mounting brackets until the tip of the brackets can be seen showing a 5/16” hole.
6. Insert a speed pin hanging from a chain on each upper bracket into the holes to secure the frame onto the canister.