Nova gear NG-52, Инструкция по эксплуатации

Страница: 14 / 20

14
SANDING
CHOOSING THE CORRECT SANDING PAPER:
Sanding paper is rated according to the
number marked on the rear of the
sanding paper. The higher the number, the
smaller and less coarse the particles
are on the sanding paper. The lower the
number, the larger and more coarse the
particles are on the sanding paper, this
will provide a more aggressive sanding
action for quick material removal.
› Coarse grit (eg.40) is used for removing
paint and sanding down rough surfaces.
› Medium grit (eg.80) is used for sanding
down plain timber.
› Fine grit (eg.120) is used to give a smooth
finish to bare wood.
› Extra fine grit (eg.400-1200) is used for
polishing or sanding between coats of
paint.
NOTE : When using the Multi-function Tool
in sanding application, try not to apply
excessive pressure when using course grit
paper as this can lead to swirl marks on
the work piece.
NOTE: Ensure you have the correct
sanding paper for your application. Always
test on a scrap work piece before using on
your final work piece.
1. In sanding mode, the Multi-function Tool
can be used on materials such as wood,
plastic, metal and painted surfaces.
2. Slide the on/off switch forward to the
“on” position. Ensure the Multi-function
Tool is not placed on the work piece.
3. Select the desired oscillation frequency
speed on the variable speed dial and
wait until the motor reaches its maximum
speed.
4. Place the Multi-function Tool on your
work piece, ensuring the whole area of
the sanding base is in contact with the
work surface.
5. Allow the Multi-function Tool to do the
work and do not apply heavy pressure on
the Multi-function Tool. Heavy pressure
does not increase the removal of material
but will wear your sanding paper faster.
6. If sanding corners in hard to reach
areas use the tip or triangle edge of the
hook & loop sanding pad.
NOTE: For best results, the sanding pad
must be kept flat on the work piece. Do
not tilt the sanding base and use the
edge of the sanding paper or the sanding
pad may become damaged, causing the
sanding paper not to adhere to the base
correctly.
SQUARE BLADE SAWING
NOTE: Ensure your blades are not blunt or
damaged in any way before commencing
your application.
Caution: Clamp your work piece
securely if possible before
commencing your work.
!