Nova gear NG-305, Инструкция по эксплуатации

Страница: 11 / 24

11
ADJUSTING THE BEVEL ANGLE
The bevel lock knob is used to lock the
cutting head at the required bevel
angle. The Mitre Saw bevel cuts from 0° to
45°.
1. Pull the bevel lock knob to release the
bevel lock (Fig. 6).
2. Rotate the handle (Fig. 7) to release
the lock. Rotate the cutting head to the
required bevel angle as shown by the bevel
angle indicator (Fig. 8).
3. Turn the bevel lock knob until firm. Push
the bevel lock knob to lock into place.
LOCKING AND UNLOCKING THE SLIDING
MECHANISM.
Always lock the sliding mechanism before
transporting or storing the saw.
To unlock it, loosen the slide lock (Fig. 9)
by turning it counterclockwise. To lock
it, tighten the slide rail lock by turning it
clockwise.
CHANGING THE BLADE
When fitting a new blade, check the
squareness of the blade to the mitre
table prior to use.
Refer to the Maintenance section of this
manual for instructions.
Warning: Ensure the bevel lock knob
is tight before making a cut. If it is not
secured, the cutting head may move
during operation and cause serious
personal injury.
!
Bevel lock
knob
Fig.6
Fig.7
Bevel rotation handle
Fig.8
Bevel angle
indicator
Fig.9
Slide lock