Nova gear NG-305, Инструкция по эксплуатации

Страница: 22 / 24

22
NOVA GEAR
MANUFACTURING PROCESS
WASTE DISPOSAL &
RECYCLING
SERVICING
Nova Gear enforces stringent
manufacturing processes to ensure
highest of quality and performance in
all of its products. Due to modern day
manufacturing processes it would be
considered unusual to have a missing
part or an operational / manufacturing
fault. Should you find anything wrong with
this product or if it doesn’t appear to your
expectations then do not operate this tool
until the parts have been replaced or the
expectation satisfied.
Do not dispose of this product in
household waste!
Please recycle this product responsibly in
accordance with local and national law.
For information on servicing and repairs
please contact Spot-on on 1300 658 338
or visit www.spoton.com.au.
CARBON BRUSHES
When the carbon brushes wear out,
the Mitre Saw will spark and/or stop.
Discontinue use as soon as this
happens. They should be replaced prior
to recommencing use of the Mitre Saw.
Carbon brushes are a wearing component
of the Mitre Saw and therefore not covered
under warranty. Continuing to use the Mitre
Saw when carbon brushes need to be
replaced may cause permanent damage
to the tool. Carbon brushes will wear out
after many uses. When the carbon brushes
need to be replaced take the Mitre Saw to
an electrician or a power tool repairer for
a quick and low cost replacement. Always
replace both carbon brushes at the same
time.
NOTE: Nova Gear will not be responsible
for any damage or injuries caused by the
repair of the Mitre Saw by an unauthorised
person or by mishandling of the Mitre Saw.
CLEANING
› Keep the ventilation vents of the Mitre
Saw clean at all times, if possible, prevent
foreign matter from entering the vents.
› After each use, blow air through the Mitre
Saw housing to ensure it is free from all
dust particles which may build up. Build up
of dust particles may cause the Mitre Saw
to overheat and fail.
› If the enclosure of the Mitre Saw requires
cleaning do not use solvents but a moist
soft cloth only. Never let any liquid get
inside the Mitre Saw; never immerse any
part of the Mitre Saw into a liquid.
GENERAL INSPECTION
Regularly check that all the fixing screws
are tight. They may vibrate loose over time.
CLEARING JAMMED MATERIAL
If your material becomes trapped or
jammed, follow the procedure below:
1. Turn machine “OFF” by releasing the
trigger switch and allow the blade to come
to a complete stop.
2. Unplug the machine from the mains
power supply.
3. Carefully remove any jammed material
from the machine.
4. Check for damage and the condition and
operation of the blade, blade guard and all
other parts of the machine.
5. Have any damaged parts replaced by a
competent technician and a safety
inspection carried out before using the
machine again.
accurate.
8. If the cut is not square, repeat steps 1-7
to set the blade square.