Norwood Kwik-Till HSD2500, Руководство оператора

Страница: 84 / 154

4 - WORKING OPERATIONS
4-18
FIELD OPERATION
Before Entering Field Guidelines
1. Read the Operator’s Manual before operating.
2. Check all lubrication points and grease as instruct-
ed in the maintenance section.
(See “5.0 MAINTE-
NANCE” on page 5-1)
3. Use recommended size tractor.
(See”Tractor Engine
Power Requirements” on page 7-1)
4. Be sure that tractor and machine have been properly
prepared. Check that the unit is properly attached
to the tractor. On pull-type unit, be sure there is a
mechanical retainer through the draw-bar pin and the
safety chain is installed.
(See “Attaching Kwik-Till To
Tractor” on page 3-9)
5. Check tire pressure.
(See”Tire Specifications” on
page 7-3)
6. Inspect all hydraulic lines, hoses, couplers, and
fittings. Tighten, repair, or replace any leaking or
damaged components.
7. Inspect, or torque all specified hardware. (See “5.0
MAINTENANCE” on page 5-1)
8. Fully charge hydraulic system.
Tighten Hardware
350 ft-lbs
475 N-m
10
50
Check tightness of all bolts after first 10 hours of then every
50 hours thereafter. Tighten all bolts to torques specified in
the Maintenance Section unless otherwise noted. (See “5.0
MAINTENANCE” on page 5-1)
Leveling the Hitch
The Kwik-Till must be parallel to the ground when the Kwik-
Till is operating in the field. A level hitch will reduce issues
in the field.
Attach the Kwik-Till to the tractor. Set tractor hitch sway limit -
ers for ‘No Sway’ operation. Check the tractor and Kwik-Till
for correct tire pressure and adjust as necessary.
1. Lower the Kwik-Till to the Field Lowered Position, by fully
retracting the Rear Roller
A
and Front Wheel Cylinders
B
. The cylinders will bottom out on the Depth Stops
C
, and the disks will engage the soil at the set depth.
(See
Fig. # 4-49)
C
A C
B
Fig. # 4-49 Field Lowered Position
2. If the hitch is not level as shown
(See Fig. # 4-50)
&
(See
Fig. # 4-51)
, then adjust the Hitch Link position on the
hitch tongue.
(See Fig. # 4-52)
&
(See Fig. # 4-53)
on the
following pages to adjust the clevis.
Front Of Hitch
Too High
Raise
Hitch
Link
Fig. # 4-50 Kwik-Till Not Level - Raise Hitch Link (Down-
ward Angle)